TECBOND 7713 / 12mm Polyamide Glue Sticks

FDA approved 12mm polyamide adhesive with good heat resistance

  • Adhesive Type: Polyamide
  • Carton Qty Approx: 100 stick pack approx. 2.5 kilos
  • Molten Tack: Medium
  • Open Time: Medium
  • Heat Resistance: 70°C
See the full specification
Made In Britain

Glue Calculator


Select Dots or Beads

Select Glue Amount (KG)

Price Options:

Buying in bulk, need a better price?
Call: 0161 627 1001

Available Options:

* Colour


There are no reviews for this product, Be the first...
Read Write
Give us a call on 0161 627 1001

Overview Show

Tecbond 7713 is a polyamide adhesive that can be used for general assembly applications where good heat resistance is required; it is also suitable for knot filling/wood repair in the woodworking industry.

Tecbond 7713 exhibits good adhesion to many surfaces and provides a tough rigid bond when set. The open time depends on the amount of adhesive applied but is described as medium (15-30 seconds).

Knot filling / Wood repair

The flow characteristics and low shrinkage make it ideal for knot filling and other wood repairs. It is exceptionally easy to trim with a sharp knife, chisel or Mouseplane, and can be easily sanded to a fine finish. Use for general applications where an easy-to-trim and easy-to-sand product is required.

Please note: Tecbond 7713 is a polyamide based product and will consequently absorb small amounts of moisture from the atmosphere. This does not affect the performance of the adhesive, however, even a small amount of moisture contamination will turn into a large amount of steam at glue gun temperature. This will cause the glue gun to drip, foam and the glue stick to back up. Please keep the adhesive sealed in the special packs provided. Moisture contaminated adhesive may be dried in an oven at 70c for 24-48 hours.

All constituent parts of this adhesive have been approved by the American F.D.A under C.F.R 21.175.105 (adhesives).

Need a better price we will try and beat any competitors price - Price Promise

For use with all Tec 12mm glue guns.


Important: Hot Melt Adhesives do have limitations! Being a thermoplastic product hot melt adhesives soften with heat and return to a solid state by the loss of heat. With this in mind, standard hot melt adhesives are not recommend for applications subjected to heat or direct sunlight. However we do offer grades with high heat resistance. Water and hot melt adhesives are a bad combination – standard hot melt adhesives are not waterproof and should be avoided for external applications. On saying this, we do have PUR adhesives that can be use externally and can even be dry cleaned. We strongly recommend that you thoroughly test the product and satisfy yourselves that the product is suitable for your application. This product suggested uses are a generalised suggestion and other factors may play a role in achieving the required bond, e.g. heat resistance, chemical resistance, gap filling, surface area to glue, open time or a degree of glue flexibility may be required etc.

What is a hot melt adhesive ?


Please contact our technical team on 0161 627 1001 to discuss your application in further detail.

Full Specification Show

  • Adhesive Type: Polyamide
  • Carton Qty Approx: 100 stick pack approx. 2.5 kilos
  • Molten Tack: Medium
  • Open Time: Medium
  • Heat Resistance: 70°C
  • Diameter: 12mm
  • Length: 250mm

Downloads Show

Material Safety Datasheet

Reviews Show

Loading Reviews...

Write a Review Show