Rakoll® Supermelt Plus Unfilled EVA

Plastic edges (PVC, ABS, PP), melamine, HPL, wooden edges, etc. to chipboard or MDF panels

  • Softening Point: Approx. 106c
  • Technology: EVA Hot Melt Adhesive
  • Product Type: Unfilled transparent
  • Application: Edge banding
  • Appearence: Granules - 20 kilo bag
See the full specification

Buying in bulk?
Need a better price?
Call 0161 627 1001

Price Options:

Quantity:

There are no reviews for this product, Be the first...
Read Write
NEED SOME HELP?
Give us a call on 0161 627 1001

Overview Show

Developed for the bonding of edge materials. It has been thoroughly tested on most application systems on straight edges and soft forming applications.

Plastic edges (PVC, ABS, PP ...), melamine, HPL, wooden edges, etc. to chipboard or MDF panels

Application Instructions: Set up the machine in accordance with the manufacturer’s instructions.

Recommended working conditions:

-  Room, material and adhesive temperature: 18 – 20°C
-  Moisture content of material: 8 – 10%
-  Processing temperature at the applicator roll: 180 – 200°C
-  Feed speed: at least 12 m/min


Edges strips can have very different adhesion properties, even if the base material is the same. For this reason, it is advisable to make trials if the edges are of an unknown type in order to test the suitability of the adhesive. The recommendations given by the edge strip manufacturers should be followed. The heat resistance of this product is adequate for all normal requirements for home, used in cold, moderate, dry warm and humid climates.


Heat resistance measured using the method in a test involving increasing temperatures and using 3 melamine edges, 1 PVC edge, 1 veneer edge and 2 extruded PVC-ABS edges: approx. 100°C.


-  During long stops the adhesive temperature should be lowered to 160°C to avoid premature degradation of the hot-melt adhesive characteristics.

Safety Advice:  At the recommended working temperature, the hot melt will cause burns in contact with skin. Do not inhale fumes that are released at the
working temperature. In any case, a suitable exhausting system shall be installed in the working area.

For additional information, please refer to the MSDS for safety advices.

Full Specification Show

  • Softening Point: Approx. 106c
  • Technology: EVA Hot Melt Adhesive
  • Product Type: Unfilled transparent
  • Application: Edge banding
  • Appearence: Granules - 20 kilo bag
  • IDH: 7015813440

Downloads Show

Technical Sheet
Download
Material Safety Datasheet
Download

Reviews Show

Loading Reviews...

Write a Review Show

Bad
Good