TEC 7100 43mm Glue Gun
TEC 7100 is one of a series of new generation pneumatic hot melt applicators. Probably one of the world’s highest-output hand-held hot melt applicators, the TEC 7100 is a serious alternative to bulk tank hot melt systems at a fraction of the cost.
Built to a very high standard, the TEC 7100 is totally self-contained. The most unique feature on this tool is the built-in speed loader, which holds an extra two 43mm glue cartridges in reserve. Plus, it also enables the user to re-load in seconds whilst continuing to use the tool. Gluegunsdirect.com says "due to the advanced heater housing design and the powerful dual 500 watt heaters, the TEC 7100 is able to dispense up to 5 kilos of molten hot melt per hour."
Operating temperature is obtained in only 5 minutes from cold via one of the 500 watt cartridge heaters, when the trigger is pulled for use, the second 500 watt heater comes into operation and enables the molten adhesive to be dispensed at a constant temperature. Being solvent free and non-toxic there are no environmental problems that are often associated with other adhesive fixing systems, which is a huge advantage with new European Environmental standards being recognised.
TEC 7100 is supplied complete with an integral gun stand, suspension ring and full operating instructions
Only use specified Tecbond 43mm glue slugs / cartridges within the Tec 43mm glue gun range -click Here
Details of the Tec applicator warranty - Click Here
Full Specification Show
- Voltage: 110 or 240 Volt
- Hotmelt Gun: 195°C or 215°C Polyamide
- Lowmelt Gun: 130°C
- Melt Rate: 5kg/hr
- Wattage: 1000 Watt
- Heater: Cartridge
- Temp Control: Interchangeable thermostat
- Power Cable: 3m
- Weight: 2.3kg